Cylindrical Treat Box


It’s not often that you see a Cylindrial box, in the almost 5 years that I have been a demonstrator with Stampin’ Up! I have seen plenty of cuboid, cubes, slopey lids, hexagons, octagons etc but very rarely have I seen a cylinder.

I like to challenge myself every now and again, so decided it was time to see if I could bring one together that could be replicated dozens of times. I’m happy to say that I think I’ve achieved this and not only is today’s project a cylindrical box, it is a flush lidded cylinder box.

The treat box uses one of the larger circles from the Layering Circles dies to help form the base and the lid, with a technique shown in my video to help curve the card and stop it from kinking. The box in the video is a Halloween version, but I just love the Christmas one in the photo above too.

The below tutorial was filmed during my TFI Crafty Friday Facebook Live, in which some of the measurements I listed were for a different size box.  To make a box the same as the image above you will need to follow the measurements lower down on this post.

Please have a go at making your own and if you have instagram, please tag them with #yourfavouriteyorkshiredemo or #hullahbaloo so that I can come see them!


Best Wishes,


  • Cardstock:
    • 1 piece = 85/8 x 21/2 inches
    • 1 piece = 85/8 x 13/4 inches
    • 1 piece = 811/16 x 11/4 inches
  • Designer Series Paper:
    • 1 piece = ½ x 811/16 inches
    • 1 piece = 1½ x 811/16 inches
  • Die Cuts:
    • 4 circles = 23/4 inches
    • 1 DSP circle = 21/2 inches


  • Score both the 85/8 x 13/4 and 811/16 x 11/4 inches at ½ inch on the short sides.
  • Then every ½ inch on the long side with the ½ inch section at the top.


Leave a Reply

Your email address will not be published. Required fields are marked *